Automotive Repair Tools

• Air bag removal tool is used to remove drivers air bag from steering wheel on 1999-04 new bodystyle VW PASSAT; JETTA; GOLF and BEETLE.

AirBag Release Tool design for fast release of the retention springs for removal of the steering wheel airbag module on GM models.

Subframe Bush Remover is a specially designed tool for removing and installing the rear subframe on a FORD MONDEO.

This unique tool has been developed to remove and install the water pump on DADILLAC NORTHSTAR 4.6 LITER V-8 engines from 1993 and later also oldsmobile AURORA 4.0 LITER V-8 engines 1995 and later.

Hydraulic Ram & Slide Hammer Puller Set.

• Use for internal & external applications.
• Supplied with 4 pairs of interchangeable tips.
• T-bar handle with screw action for precise control.

• The steering wheel level is a sturdy and simple tool used to assure a level steering wheel during a front-end alignment procedure.
• The tool is easily attached to the steering wheel at the beginning of the alignment procedure.
• It is spring-loaded for automatic centering and self-retaining.

• This pin is used to lock the crankshaft at the TDC position while replacing the timing belt or removing the crankshaft bolt.
• Applicable: VW / AUDI models with 2.7 & 2.8 liter V6 engines.
• Size: M18x1.5

Clip Remover Tool design to use for self-locking cowling clips.

Spanner Wrench can use for the adjustment of the timing belt.

• This unique tool has been developed to aid in the removal and installation of the crank bolt on most HONDA and ACURA engines.
• It has been re-engineered to work on 2004 and later new style SUV's with a 50mm damper pulley as well as all previous models serviced.
• In operation with the use of a 1/2 inch breaker bar or ratchet this tool holds the harmonic damper pulley from rotating when removing and setting the final torque specification on the pulley bolt.
• There is a hole in the center of the tool to allow the use of a socket and extension to break loose or tighten the pulley bolt.

• The identifiers are commonly used when tuning the engine or working on the carburetor.
• Identifiers can also be used to plug fuel lines while changing.